Software Configuration; Removing The Ufm Board; Required Tools - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual
Hide thumbs
Also See for PRIMERGY TX300 S7:
- Upgrade and maintenance manual (962 pages) ,
- Operating manual (90 pages) ,
- System configurator and order-information manual (36 pages)
Table of Contents
Advertisement
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
14.2.1.5 Software configuration
The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.
14.2.2 Removing the UFM board
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
14.2.2.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing the UFM:
●
– Phillips PH0 / (+) No. 0 screw driver
TX300 S7 / RX350 S7
125.
156.
Upgrade and Maintenance Manual
System board and components
"Connecting the server to
150.
"Enabling SVOM
"Enabling
763
Advertisement
Table of Contents
