Show Config - Dell Z9500 Reference Manual

Table of Contents

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

You must have an IP address assigned to an interface to enter ROUTER OSPF mode

and configure OSPF.

After the OSPF process and the VRF are tied together, you cannot use the OSPF

Process ID again in the system.

Dell(conf)#router ospf 2

Dell(conf-router_ospf)#

show config

Display the non-default values in the current OSPF configuration.

Open Shortest Path First (OSPFv2 and OSPFv3)

Enter a number for the OSPF instance. The range is from 1 to

(Optional) E-Series Only: Enter the VRF process identifier to

tie the OSPF instance to the VRF. All network commands

under this OSPF instance are then tied to the VRF instance.

Introduced on the Z9500.

Added support for OSPFv3 on the S4810 and Z9000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for VRF.

Added support for Multi-Process OSPF.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.