Dell Z9500 Reference Manual page 1261

Table of Contents

If you delete all the network area commands for Area 0, the show ip ospf

command output does not list Area 0.

The following describes the show ip ospf command shown in the following

Line Beginning

"Supports only..."

"SPF schedule..."

"Convergence

"Min LSA...."

"Number of..."

Dell#show ip ospf 10

Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-

Supports only single TOS (TOS0) routes

SPF schedule delay 5 secs, Hold time between two SPFs 10 secs

Convergence Level 0

Min LSA origination 0 msec, Min LSA arrival 1000 msec

Min LSA hold time 5000 msec, Max LSA wait time 5000 msec

Number of area in this router is 1, normal 1 stub 0 nssa 0

Open Shortest Path First (OSPFv2 and OSPFv3)

Introduced on the S4820T.

Introduced on the Z9000.

Added output for LSA throttling timers.

Introduced on the S4810.

Added support of Multi-Process OSPF.

Added the process-id option, in support of Multi-Process

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Displays the OSPF process ID and the IP address associated

with the process ID.

Displays the number of Type of Service (TOS) rouse

Displays the delay and hold time configured for this process

Displays the intervals set for LSA transmission and

Displays the number and type of areas configured for this

Area BACKBONE (0)

Number of interface in this area is 1

SPF algorithm executed 205 times