Bridge-Priority; Debug Spanning-Tree - Dell Z9500 Reference Manual

Table of Contents

bridge-priority

Set the bridge priority of the switch in an IEEE 802.1D spanning tree.

bridge-priority {priority-value | primary | secondary}

To return to the default value, use the no bridge-priority command.

priority-value

priority-value = 32768

SPANNING TREE (The prompt is "config-stp".)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enable debugging of the spanning tree protocol and view information on the protocol.

debug spanning-tree {stp-id [all | bpdu | config | events |

exceptions | general | root] | protocol}

Spanning Tree Protocol (STP)

Enter a number as the bridge priority value. The range is

from 0 to 65535. The default is 32768.

Enter the keyword primary to designate the bridge as the

root bridge.

Enter the keyword secondary to designate the bridge as a

secondary root bridge.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.