Tunnel Flow-Label - Dell Z9500 Reference Manual

Table of Contents

0 (Mapped using IPv6 traffic)

INTERFACE TUNNEL (conf-if-tu)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

tunnel flow-label

Configure the method to set the IPv6 flow label value in the outer tunnel header.

tunnel flow—label value

To return to the default value of 0, use the no tunnel flow—label value

Tunneling Commands

Enter the keyword mapped to map IPv6 traffic class/IPv4

DSCP to the IPv4 DCSP\IPv6 traffic class. This option copies

the IPv6 traffic class/IPv4 DSCP in the encapsulated packet

to the tunnel header.

Enter a value to set the DSCP value in the tunnel header. The

range is from 0 to 63. The default value of 0 denotes

mapped traffic.

Introduced on the Z9500.

Introduced on the Z9000, S4810, and S4820T.

This command configures the method used to set the high 6 bits (the

differentiated services codepoint) of the IPv4 TOS or the IPv6 traffic class in the

outer IP header.

A value of 0 copies the original packet DSCP (IPv4) or Traffic Class (IPv6) to the

tunnel header DSCP or Traffic Class. DSCP or Traffic Class depends on the

tunnel mode.

Enter a value to set the IPv6 flow label value in the tunnel

header. The range is from 0 to 1048575. The default value is