Tunnel Hop-Limit - Dell Z9500 Reference Manual
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Defaults
0 (Mapped using original packet flow-label value to the tunnel header flow-label
value.)
Command
INTERFACE TUNNEL (conf-if-tu)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.2)
Usage
This command is only valid for tunnel interfaces with an IPv6 outer header.
Information
tunnel hop-limit
Configure the method to set the IPv4 time-to-live or the IPv6 hop limit value in the outer tunnel header.
Z9500
Syntax
tunnel hop—limit value
To restore the default tunnel hop-limit, use the no tunnel hop—limit
command.
Parameters
value
Defaults
64 (for IPv4 and IPv6)
Command
INTERFACE TUNNEL (conf-if-tu)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.2)
1758
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Enter the hop limit (IPv6) or time-to-live (IPv4) to include in
the tunnel header. The range is from 0 to 255. The default is
64.
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Tunneling Commands
Advertisement
Table of Contents
