Tunnel Source - Dell Z9500 Reference Manual

Table of Contents

tunnel source

Set a source address for the tunnel.

tunnel source {ip-address | ipv6–address | interface-type-

To delete the current tunnel source address, use the no tunnel source

ipv6-address

interface-type-

INTERFACE TUNNEL (conf-if-tu)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.5(0.0)

Version 9.2(0.2)

If you have configured a tunnel interface or destination address, the tunnel source

must be compatible for this command to function. If you configure the tunnel

source address as an interface, the tunnel does not function unless a compatible

address is present on the specified interface.

If you configure the tunnel source address as tunnel source interface, the

lowest address is used. This address is not changed even if you configure a lower

address on the selected interface. To change the selected address, reload or

recreate the tunnel or remove the selected address from the interface.

Enter the source IPv4 address in A.B.C.D format.

Enter the source IPv6 address in X:X:X:X::X format.

For a 1–Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Port Channel interface, enter the keyword port-

channel. The range is from 1 to 512.

For a 10–Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40–Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the Z9500.

Introduced on the Z9000, S4810, and S4820T.

Tunneling Commands