Debug Uplink-State-Group - Dell Z9500 Reference Manual
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Related
•
Commands
•
debug uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
Z9500
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id
Defaults
none
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
1762
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
downstream
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group
— creates an uplink-state group and enables the tracking of
upstream links.
Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Uplink Failure Detection (UFD)
Advertisement
Table of Contents
