Dell Z9500 Reference Manual page 940

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This command provides egress port information for a given IP flow. This

information is useful in identifying which interface the packet follows in the case of

Port-channel and Equal Cost Multi Paths. Use this command for routed packed

only. For switched packets, use the show port-channel-flow command.

The show ip flow command does not compute the egress port information

when load-balance mac hashing is also configured due to insufficient

information (the egress MAC is not available).

S-Series produces the following error message: %Error: Unable to read IP

route table.

Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol

tcp source-port 7898 destination-port 8

flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976

Ingress interface:Te 1/20

Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710]

unfragmented packet

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the E-Series ExaScale.

Introduced VRF on the E-Series.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented

IPv4 Routing