Dell Z9500 Reference Manual page 942
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.2
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Usage
The following describes the show ip interface command shown in the
Information
following example.
Lines
TenGigabitEthern
et 1/1...
Internet address...
IP MTU is...
Inbound access...
Proxy ARP...
Split horizon...
Poison Reverse...
ICMP redirects...
ICMP
unreachables...
Example
Dell#show ip int te 1/1
TenGigabitEthernet 1/1 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
942
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Supported on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the interface's type, slot/port, and physical and line
protocol status.
States whether an IP address is assigned to the interface. If
an IP address is assigned, that address is displayed.
Displays IP MTU value.
Displays the name of the configured incoming access list. If
none is configured, the phrase "not set" is displayed.
States whether proxy ARP is enabled on the interface.
States whether split horizon for RIP is enabled on the
interface.
States whether poison for RIP is enabled on the interface.
States if ICMP redirects are sent.
States if ICMP unreachable messages are sent.
IPv4 Routing
Advertisement
Table of Contents
