Dell Z9500 Reference Manual page 959

Table of Contents

ipv4acl 1- 4

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

For the new settings to take effect, save the new CAM settings to the startup-

config (write-mem or copy run start), then reload the system.

The total amount of space allowed is 16 FP Blocks. System flow requires three

blocks and these blocks cannot be reallocated.

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile

which is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

Dell#configure

Dell(conf)#cam-acl-egress ?

Dell(conf)#cam-acl-egress l2acl ?

Dell(conf)#cam-acl-egress l2acl 1 ?

IPv6 Access Control Lists (IPv6 ACLs)

Use the default CAM profile settings, and set the CAM as

L2 ACL(l2acl): 1

L3 ACL (ipv4acl: 1

IPv6 L3 ACL (ipv6acl): 2

Allocate space to support IPv6 ACLs. Enter all of the profiles

and a range. Enter the CAM profile name then the amount to

be allotted. The total space allocated must equal 13. The

ipv6acl range must be a factor of 2.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series TeraScale.

Introduced on the S-Series.

Introduced on the C-Series.

Reset Egress CAM ACL entries to default setting

Set L2-ACL entries

Number of FP blocks for l2acl