Permit Tcp (For Ipv6 Acls) - Dell Z9500 Reference Manual

Table of Contents

standard or extended access-lists. This mechanism copies all incoming or outgoing

packets on one port and forwards (mirrors) them to another port. The source port

is the monitored port (MD) and the destination port is the monitoring port (MG).

permit (for Standard IPv6 ACLs)

permit tcp (for IPv6 ACLs)

Configure a filter to pass TCP packets that match the filter criteria.

permit tcp {source address mask | any | host ipv6-address}

[operator port [port]] {destination address | any | host ipv6-

address} [bit] [operator port [port]] [count [byte]] [log

[interval minutes] [threshold-in-msgs [count]] [monitor]

To remove this filter, you have two choices:

threshold-in

By default, 10 ACL logs are generated if you do not specify the threshold explicitly.

The default frequency at which ACL logs are generated is 5 minutes. By default,

flow-based monitoring is not enabled.

Use the no seq sequence-number command if you know the filter's

sequence number.

Use the no permit tcp {source address mask | any | host ipv6-

address} {destination address | any | host ipv6-address}

(OPTIONAL) Enter the keyword log to enable the triggering

of ACL log messages.

(OPTIONAL) Enter the threshold-in-msgs keyword

followed by a value to indicate the maximum number of ACL

logs that can be generated, exceeding which the generation

of ACL logs is terminated. with the seq, permit, or deny

commands. The threshold range is from 1 to 100.

(OPTIONAL) Enter the keyword interval followed by the

time period in minutes at which ACL logs must be generated.

The interval range is from 1 to 10 minutes.

(OPTIONAL) Enter the keyword monitor when the rule is

describing the traffic that you want to monitor and the ACL

in which you are creating the rule is applied to the monitored

– configures a filter to forward IPv6 packets.

IPv6 Access Control Lists (IPv6 ACLs)