Dell Z9500 Reference Manual page 977

Table of Contents

EXEC Privilege

This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when

verifying QoS optimization for IPv6 ACLs.

QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a

policy on a single (or the first of several) interfaces. It is most useful when a policy

is applied across multiple interfaces; it can reduce the impact to CAM usage across

subsequent interfaces.

The following describes the test cam-usage command shown in the Example

CAM Partition

Available CAM

Estimated CAM

Dell#test cam-usage service-policy input LauraMapTest linecard

Linecard|Portpipe|CAM Partition|Available CAM|Estimated CAM

per Port|Status

--------------------------------------------------------------

IPv6 Access Control Lists (IPv6 ACLs)

Introduced on the Z9500.

Introduced on the E-Series ExaScale.

Introduced on the C-Series and E-Series TeraScale.

Introduced on the S-Series.

Introduced on the E-Series ExaScale.

Introduced on the C-Series and E-Series TeraScale.

Lists the line card or linecards that are checked. Entering

all shows the status for linecards in the chassis.

Lists the portpipe (port-set) or port pipes (port-sets) that are

checked. Entering all shows the status for linecards and

port-pipes in the chassis.

Shows the CAM profile of the CAM.

Identifies the amount of CAM space remaining for that

Estimates the amount of CAM space the listed policy

Indicates whether or not the policy is allowed in the CAM