Ipv6 Nd Prefix - Dell Z9500 Reference Manual

Table of Contents

To remove the IPv6 RDSS configuration, use no ipv6 nd dns-server {ipv6-

RDNSS-address} {lifetime | infinite}

Not Configured

INTERFACE CONFIG

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.5(0.0)

Use this command to add, edit, or delete an IPv6 RDNSS address and lifetime value.

You can configure up to four IPv6 RDNSS addresses. You must specify a lifetime

using the lifetime or infinite parameter.

Dell(conf-if-te-0/1)#ipv6 nd dns-server 1000::1 1

ipv6 nd prefix

Specify which IPv6 prefixes are included in Neighbor Advertisements.

ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-

advertise] | [no-autoconfig] [no-rtr-address] [off-link]

[lifetime {valid | infinite} {preferred | infinite}]

prefix-length

Enter the IPv6 Recursive DNS Server's (RDNSS) address. You

can specify up to 4 IPv6 RDNSS server addresses.

Enter the lifetime in seconds. The amount of time the IPv6

host can use the IPv6 RDNSS address for name resolution.

The range is 0 to 4294967295 seconds. When you specify

the maximum lifetime value of 4294967295 or infinite,

the lifetime does not expire. A value of 0 indicates to the host

that the RDNSS address should not be used. You must

specify a lifetime using the lifetime or infinite

Enter the keyword infinite to specify that the RDNSS

lifetime does not expire.

Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Enter an IPv6 prefix.

Enter the prefix then the prefix length. The length range is

from 0 to 128.