Dell Z9500 Reference Manual page 991

Table of Contents

no-advertise

no-autoconfig

no-rtr-address

valid-lifetime |

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

By default, all prefixes configured as addresses on the interface are advertised. This

command allows control over the individual parameters per prefix; you can use the

default keyword to use the default parameters for all prefixes. If a prefix has been

configured with lifetime parameter values, the default values cannot be applied

using the ipv6 nd prefix default no-autoconfig command.

Enter the keyword default to set default parameters for all

Enter the keyword no-advertise to prevent the specified

prefix from being advertised.

Enter the keywords no-autoconfig to disable Stateless

Address Autoconfiguration.

Enter the keyword no-rtr-address to exclude the full

router address from router advertisements (the R bit is not

Enter the keywords off-link to advertise the prefix without

stating to recipients that the prefix is either on-link or off-

Enter the amount of time that the prefix is advertised, or

enter infinite for an unlimited amount of time. The range

is from 0 to 4294967295. The default is 2592000. The

maximum value means that the preferred lifetime does not

expire for the valid-life time parameter.

Enter the amount of time that the prefix is preferred, or enter

infinite for an unlimited amount of time. The range is

from 0 to 4294967295. The default is 604800. The

maximum value means that the preferred lifetime and does

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series TeraScale, C-Series, and S-