Ipv6 Unicast-Host-Route; Ipv6 Unicast-Routing - Dell Z9500 Reference Manual
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Configuration manual (953 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
ipv6 unicast-host-route
Enable the storage of extended IPv6 route prefixes (/65 to /128) in the L3 host table.
Z9500
Syntax
[no] ipv6 unicast-host-route
Defaults
Enabled; by default, extended IPv6 route prefixes are stored only in the L3 host
table.
Command
CONFIGURATION
Modes
Command
Version
History
9.5(0.1)
9.3(0.1)
Usage
Use this command to enable programming of extended IPv6 (/65 to /128) route
Information
prefixes in the L3 host table. A warning message is displayed after you enter the
command stating that this setting takes effect for existing routes only when IPv6
route prefixes are cleared from the LPM routing table (RTM). To enable storage of
extended IPv6 route prefixes in the LPM table, disable this setting by entering the
no ipv6 unicast-host-route command.
Example
Dell(conf)# ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#
ipv6 unicast-routing
Enable IPv6 Unicast routing.
Z9500
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults
Enabled
Command
CONFIGURATION
Modes
996
Description
Introduced on the Z9500.
Introduced on the S6000.
IPv6 Basics
Advertisement
Table of Contents
