Table of Contents
Advertisement
Installing a 3.5-inch Hard Disk Drive
Follow the procedure as described below to install 3.5-inch hard disk drives.
1. Configure the operation mode of hard disks according to the manual supplied
with the hard disk.
Hard Disk
First hard disk drive
Second hard disk drive
Third hard disk drive
Fourth hard disk drive
*An optional SCSI controller or RAID controller is required for installing SCSI hard
disk.
NB: Set the SCSI termination to "OFF" for all hard disks.
Hard Disk
First hard disk drive
Second hard disk drive
Third hard disk drive*
Fourth hard disk drive*
* An optional RAID controller is required to install more than two hard disks.
2. Read section "Preparing Your Server for Upgrade" on page 3
3. Remove the right side door. See "Removing or Installing the Right Side Door"
on page 4
4. Remove the front panel. See "Removing and Replacing the Front Panel" on
page 8
5. Disconnect the interface cable and power cord from the hard disk drive if
connected.
NS170 User Guide - Upgrading Your Server
Table 4 - 2: SCSI Hard Disk Drives*
SCSI ID
ID0
ID1
ID2
ID3
Table 4 - 3: Serial ATA Hard Disk Drives
Bay to install
Top
Upper middle
Lower middle
Bottom
Bay to install
Top
Upper middle
Lower middle
Bottom
4 - 22
SCSI Termination
OFF
OFF
OFF
OFF
Advertisement
Table of Contents
