Table of Contents
Advertisement
11. Insert the file bay into the server and push it until a click occurs to lock it.
12. Connect the interface and power cables to the 5.25-inch device installed from
one side of the server. See "Cabling the Devices" on page 42
(A) so that the end with the red line (B) indicating pin 1 faces the
motherboard.
13. Assemble the server.
14. If a SCSI device is installed, set the parameters including the transmission rate
using the BIOS utility of the SCSI controller. Refer to the manual provided
with the SCSI controller for details.
Removing a file device
The file device can be removed in the reverse order of the installation. If the device is
removed but not installed again, install the EMI and dummy covers.
NS170 User Guide - Upgrading Your Server
Figure 4 - 17 : Pushing the File Bay
Note:
Connect the interface cable of the floppy disk drive
A
Figure 4 - 18 : Connecting Cables
4 - 15
B
Advertisement
Table of Contents
