Table of Contents
Advertisement
DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
S
RED C
IMPLE
Back to Section Header
The Simple RED commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
enable sred
disable sred
config sred
show sred
show sred drop_counter
config dscp trust
show dscp trust
config dscp map
show dscp map
config 802.1p map
show 802.1p map 1p_color
Each command is listed, in detail, in the following sections.
enable sred
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable sred:
DGS-3700-12:5#enable sred
Command: enable sred
Success.
DGS-3700-12:5#
disable sred
Used to disable the simple RED function.
Purpose
Syntax
disable sred
This command is used to disable the sRED function.
Description
None.
Parameters
Restrictions
Only Administrator and Operator-level users can issue this command.
OMMANDS
P
ARAMETERS
[<portlist>|all] [<class_id 0-7>|all] { threshold {low <value 0-
100>|high<value 0-100>} | rop_rate {low<value 1-8>|high<value 1-8>}|
drop_green [enable|disable]}
{ <portlist>{ <class_id 0-7>}}
{<portlist>}
[<portlist>|all] state [enable|disable]
{<portlist>}
[<portlist>|all] [dscp_priority <dscp_list> to <priority 0-7>| dscp_dscp
<dscp_list> to <dscp 0-63> | dscp_color <dscp_list> to
[green|red|yellow]]
{ <portlist> } [dscp_priotity | dscp_dscp | dscp_color] {dscp <dscp_list>}
[<portlist>|all] 1p_color [<priority_list] to [green|red |yellow]
{ <portlist>}
Used to enable the simple RED function.
enable sred
This command is used to enable the sRED function. By default, sRED is disabled.
None.
Only Administrator and Operator-level users can issue this command.
Page | 355
Advertisement
Chapters
Table of Contents
