Table of Contents
Advertisement
3.5
Setting
time-out
limit
When you set the time-out
limit, you must set as follows.
<< SETUP
MODE
>>
TIME-OUT
SET
_ @At
Screen 2, press [Mode
l] five times (four
times in case of M3099G)
to go to the TIME-
OUT SET screen. (Screen
12)
Screen 12
@ Press [Mode 21 to see Screen 13. (The default
setting is 30 sec.)
TIME-OUT
SET
~------------------------------
@At
Screen 13, press [Mode
l] until the digit
___________.
xxxx
s
you want to change blinks. Then press [Mode
Screen13
I
21
until the digit changes as you want. (The
specifiable
range is from 1 to 1999 sec. in 1 sec.
step.)
@ Press [Mode
l] and [Mode 21 at a time to see
Screen
12.
The settings
are stored to
EEPROM.
@When
you close the setup mode, go to a>.
3.6
Setting
hopper
time
When you set the hopper
time, you must set as follows.
@At
Screen 2, press [Mode
l] six times (five
times in case of M3099G)
to go to the
HOPPER
TIMER
screen. (Screen
14)
Screen14
@
Press [Mode 21 to see Screen 15. (The default
setting is 7 sec.)
11
@At
Screen 15, press [Mode
11 until the digit
you want to change blmks. Then press [Mode
Screen15
21 until the digit changes as you want. (The
specifiable
range is from 0 to 30 sec. in 1 sec.
step.)
@ Press [Mode
l] and [Mode 21 at a time to see
Screen 14. The settings are stored to
EEPROM.
@When
you close the setup mode, go to 8.
M3099A/G
Operator's Guide
c-5
Advertisement
Chapters
Table of Contents
