Table of Contents
Advertisement
3.7 Reset of abrasion counter
When you reset the abrasion
counter,
you must set as follows,
@At
Screen 2, press [Mode
l]
seven times (six
times in case of M3099G)
to go to the
PAPER COUNT
RESET screen. (Screen
16)
Screen 16
@ Press ].Mode 21 to see Screen 17. You may see
Screen 17
"OFF" and current
paper count.
If you want
to reset the count,
press [Mode
11. Ifyou
want to reset the count,
press [Mode
11. If
you don't want it, press [Mode 21 to go to
Screen 16. Any time you press [Mode 21, you
can go to Screen 16.
@When
you close the setup mode, go to 8.
3.8 Setting SCSI-ID (M3099G)
When you set the SCSI-ID,
you must set as follows.
@At
Screen 2, press [Mode
l] five times to go
to the SCSI-ID
SET screen. (Screen
18)
]I
~)ress
[Mode2l
toseeScreen
19. (Thedefau,t
Screen 18
setting is "5".)
I-...--------...----.---.-...-------..---..1
@At
Screen 19, the SCSI-ID
is from 0 to 7
SCSI-ID
SET
each time you press [Mode 11.
5
@ Press [Mode 21 to see Screen 18. The settings
Screen 19
are stored to EEPROM.
@When
you close the setup mode, go to 0.
C-6
M3099A/G
Operator's
Guide
Advertisement
Chapters
Table of Contents
