Table of Contents
Advertisement
Network Setting
There are following methods for network settings.
• EPSON TMNet WebConfig:
• EpsonNet Config:
• Easy Setup:
This section briefly explains how to set from EPSON TMNet WebConfig.
Though Easy Setup requires no network connection during setup, you must specify values
for all the setting items available for EPSON TMNet WebConfig.
For about using EpsonNet Config, refer to the manual of EpsonNet Config.
For about Easy Setup, refer to "TM-i Series Easy Setup Guide".
1. Connect via a wired LAN
Connect this product and a PC for setting via a wired LAN.
To use a wireless LAN, connect the wireless LAN unit to the USB port on this product.
2. Check the IP address of this product
When this product is turned on and becomes ready for printing, it prints out the automatically
acquired IP address.
If no IP address is printed, print a status sheet and check the IP address.
3. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i's IP address/webconfig/
For detail, see
"Starting EPSON TMNet WebConfig" on page
4. Set up TCP/IP
Select the [System Settings] menu and then [Wired] - [TCP/IP] or [Wireless] - [TCP/IP], and set
TCP/IP.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
For detail, see
"System Settings - Network - Wired - TCP/IP" on page 95
Network - Wireless - TCP/IP" on page
56
Set from the computer's web browser
Set from EpsonNet Config, which is first installed on the computer.
Set from the USB memory where the configuration file is stored.
(TM-i firmware Ver.3.0 or later)
97.
77.
or
"System Settings -
Hide quick links:
Advertisement
Table of Contents
