Relocation And Maintenance - Mitsubishi Electric MSZ-FH25VE Installation Manual
Hide thumbs
Also See for MSZ-FH25VE:
- Operating instructions manual (16 pages) ,
- Installation manual (4 pages) ,
- Service manual (42 pages)
Advertisement
4. PURGING PROCEDURES, LEAK TEST, AND TEST RUN
4-1. PURGING PROCEDURES AND LEAK TEST
gas pipe side of the outdoor unit.
Stop valve cap
Service port cap
140 to
cm)
Precautions when using the control valve
Service port
Open
the vacuum pump.
5)
4-2. TEST RUN
5. RELOCATION AND MAINTENANCE
5-1. REMOVING AND INSTALLING THE PANEL ASSEMBLY
Removal procedure
shown in
and
using a thin instrument.
the right component, pull out the right top
on its upper center part.
Installation procedure
dure in reverse.
5-2. REMOVING THE INDOOR UNIT
tion plate.
Pressure gauge
Stop valve
Stop valve for
preventing the
pump with the function to
valve core is in closed position, and
core is in open position.
, and twice for
opera-
-
Upper and
lower vanes
-
-
operating instructions for details.
Checking the remote (infrared) signal reception
4-3. AUTO RESTART FUNCTION
for details.)
Caution:
To the user
4-4. SETTING THE INSTALLATION POSITION
-
Be sure to set the remote controller in accordance with the installed position of the indoor
unit.
Installation position:
than 50 cm to the left
more than 50 cm to the left and right
than 50 cm to the right
Note:
on the remote controller for 2 seconds to enter the position setting
mode.
to complete the position setting.
4-5. EXPLANATION TO THE USER
put the remote controller in the remote controller holder, how to clean, precautions for
operation
operation, etc.).
switch
5-3. PUMPING DOWN
side of the outdoor unit.
6) Stop the
tions for details.
When pumping down the refrigerant, stop the compressor before disconnecting
the refrigerant pipes. The compressor may burst if air etc. get into it.
2
).
.
WARNING
-
2
).
can
-
Advertisement
