Udld Port - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
UDLD Commands
OL-32830-01 Command Line Interface Reference Guide
Example
This example shows how to globally set the interval to 40sec:
switchxxxxxx(config)#
54.4 udld port
To enable the UDLD protocol on an Ethernet port, use the udld port command in
Interface Configuration mode. To return to the default, use the no form of this
command.
Syntax
udld port [aggressive | normal | disable]
no udld port
Parameters
•
aggressive—Enables UDLD in aggressive mode on this interface.
•
normal—Enables UDLD in normal mode on this interface. The normal
keyword is applied if no keyword is specified.
•
disable—Disables UDLD on this interface.
Default Configuration
The defaults are as follows:
•
Fiber interfaces are in the state configured by the udld command.
•
Non-fiber interfaces are in the Disable state.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Use this command on fiber ports to override the setting of the global udld
command.
udld message time 40
54
1030
Advertisement
Table of Contents
