Switchport General Pvid - Cisco 300 Series Cli Manual

Stackable managed switches

Table of Contents

Virtual Local Area Network (VLAN) Commands

OL-32830-01 Command Line Interface Reference Guide

tagged—Specifies that the port transmits tagged packets for the VLANs.

This is the default value.

untagged—Specifies that the port transmits untagged packets for the

nonconsecutive VLAN IDs with a comma and no spaces; use a hyphen to

designate a range of IDs.

Default Configuration

The port is not member in any VLAN.

Packets are transmitted untagged.

Command Mode

Interface (Ethernet, Port Channel) Configuration mode

User Guidelines

You can change the egress rule (for example, from tagged to untagged) without

first removing the VLAN from the list.

If the interface is a forbidden member of an added VLAN, the interface does not

become a member of this specific VLAN. There will be an error message in this

case ("An interface cannot become a a member of a forbidden VLAN. This

message will only be displayed once.") and the command continues to execute if

there are more VLANs in the vlan-list.

The example adds gi 1 1 to VLAN 2 and 3. Packets are tagged on the egress:

switchxxxxxx(config)#

switchxxxxxx(config-if)#

56.17 switchport general pvid

Use the switchport general pvid Interface Configuration mode command to

configure the Port VLAN ID (PVID) of an interface when it is in general mode. Use

the no form of this command to restore the default configuration.

—Specifies the list of VLAN IDs to remove. Separate

interface gi11

switchport general allowed vlan add 2-3 tagged