Switchport Customer Multicast-Tv Vlan - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide
Default Configuration
Receiving Multicast transmissions is disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When the port is assigned to a different Multicast-TV VLAN, it is automatically
removed from its previous VLAN and added it to the new Multicast-TV VLAN.
When an existed Multicast-TV VLAN is assigned to an access port, the multicast
messages received on a membership of the Multicast-TV VLAN are forwarded to
the access port. All messages received on the access port are bridged only into
its Access VLAN.
To register IGMP reports arriving on the access port by IGMP Snooping running on
the Multicast-TV VLAN, use the
Example
The following example enables gi 1 4 to receive Multicast transmissions from VLAN
11.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
56.34 switchport customer multicast-tv vlan
To assign Multicast-TV VLANs to a customer port, use the switchport customer
multicast-tv vlan command in Interface (Ethernet, Port Channel) Configuration
mode. To return to the default, use the no format of the command.
Syntax
switchport customer multicast-tv vlan {add
Parameters
•
vlan-list
add
—Specifies a list of Multicast TV VLANs to add to interface.
•
vlan-list
remove
interface.
ip igmp snooping map cpe vlan
interface gi14
switchport access multicast-tv vlan
—Specifies a list of Multicast TV VLANs to remove from
command.
vlan-list
vlan-list
| remove
56
11
}
1086
Advertisement
Table of Contents
