Bridge Multicast Forward-All - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
User Guidelines
Do not enable unregistered Multicast filtering on ports that are connected to
routers, because the 224.0.0.x address range should not be filtered. Note that
routers do not necessarily send IGMP reports for the 224.0.0.x range.
You can execute the command before the VLAN is created.
Example
The following example specifies that unregistered Multicast packets are filtered
on gi 1 1:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
5.15
bridge multicast forward-all
To enable forwarding all multicast packets for a range of ports or port channels,
use the bridge multicast forward-all Interface (VLAN) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
bridge multicast forward-all
port-channel-list}
no bridge multicast forward-all
Parameters
•
add—Forces forwarding of all Multicast packets.
•
remove—Does not force forwarding of all Multicast packets.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
interface gi11
bridge multicast unregistered filtering
{add | remove} {ethernet interface-list | port-channel
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
5
160
Advertisement
Table of Contents
