Ip Addressing Commands; Ip Address - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IP Addressing Commands
OL-32830-01 Command Line Interface Reference Guide
22.0
IP addresses and Layer 2 Interfaces
IP addresses can be configured on the following Layer 2 interfaces:
Only in router mode.
•
Port channel
•
VLAN
•
Loopback port
Lists of Commands
22.1
ip address
Use the ip address Interface Configuration (Ethernet, VLAN, Port-channel) mode
command to define an IP address for an interface. Use the no form of this
command to remove an IP address definition.
Syntax
In switch mode:
ip-address
ip address
no ip address
In router mode:
ip-address
ip address
ip-address
no ip address [
Parameters
•
ip-address
—Specifies the IP address.
mask
prefix-length
{
| /
mask
prefix-length
{
| /
]
22
default-gateway-ip-address
} [
}
]
450
Advertisement
Table of Contents
