Ip Helper-Address - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
22
463
Example
The following example enters the IP interface configuration mode.
switchxxxxxx(config)#
switchxxxxxx(config-ip)#
22.14 ip helper-address
Use the ip helper-address Global Configuration mode command to enable the
forwarding of UDP Broadcast packets received on an interface to a specific
(helper) address. Use the no form of this command to disable the forwarding of
broadcast packets to a specific (helper) address.
Syntax
ip helper-address {
ip-interface |
no ip helper-address {
Parameters
•
ip-interface
—Specifies the IP interface.
•
all—Specifies all IP interfaces.
•
address
—Specifies the destination broadcast or host address to which to
forward UDP broadcast packets. A value of 0.0.0.0 specifies that UDP
broadcast packets are not forwarded to any host.
•
udp-port-list
—Specifies the destination UDP port number to which to
forward Broadcast packets. (Range: 1–65535). This can be a list of port
numbers separated by spaces.
Default Configuration
Forwarding of UDP Broadcast packets received on an interface to a specific
(helper) address is disabled.
If udp-port-list is not specified, packets for the default services are forwarded to
the helper address.
interface ip
192.168.1.1
all}
address
ip-interface |
all}
address
OL-32830-01 Command Line Interface Reference Guide
IP Addressing Commands
[
udp-port-list
]
Advertisement
Table of Contents
