Link Aggregation Control Protocol (Lacp) Commands; Lacp Port-Priority - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Link Aggregation Control Protocol (LACP)
Commands
OL-32830-01 Command Line Interface Reference Guide
1
28.1
lacp port-priority
To set the physical port priority, use the lacp port-priority Interface (Ethernet)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
value
lacp port-priority
no lacp port-priority
Parameters
value—Specifies the port priority. (Range: 1use the no form of this
command65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example sets the priority of
switchxxxxxx(config)#
switchxxxxxx(config-if)#
gi1
interface gi16
lacp port-priority 247
28
6.
633
Advertisement
Table of Contents
