Lldp Med - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
30
649
User Guidelines
Each port can advertise one IP address.
Example
The following example sets the LLDP management address advertisement mode
to automatic on gi 1 2.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
30.6 lldp med
To enable or disable LLDP Media Endpoint Discovery (MED) on a port, use the lldp
med Interface (Ethernet) Configuration mode command. To return to the default
state, use the no form of this command.
Syntax
enable
tlv
lldp med {
[
no lldp med
Parameters
•
enable—Enable LLDP MED
•
tlv—Specifies the TLV that should be included. Available TLVs are:
Network-Policy, Location, and POE-PSE, Inventory. The Capabilities TLV is
always included if LLDP-MED is enabled.
•
disable—Disable LLDP MED on the port
Default Configuration
Disabled
Command Mode
Interface (Ethernet) Configuration mode
Link Layer Discovery Protocol (LLDP) Commands
interface gi12
lldp management-address automatic
tlv4
disable
...
] |
}
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
