Lldp Optional-Tlv - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide
30.15 lldp optional-tlv
To specify which optional TLVs are transmitted, use the lldp optional-tlv Interface
(Ethernet) Configuration mode command. To restore the default configuration, use
the no form of this command.
Syntax
tlv
tlv2
lldp optional-tlv
[
Parameters
•
tlv—Specifies the TLVs to be included. Available optional TLVs are:
port-desc, sys-name, sys-desc, sys-cap, 802.3-mac-phy, 802.3-lag,
802.3-max-frame-size.
•
none—(Optional) Clear all optional TLVs from the interface.
If the 802.1 protocol is selected, see the command below.
Default Configuration
The following TLV are transmitted:
•
sys-name
•
sys-cap
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example specifies that the port description TLV is transmitted on
gi 1 2.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
tlv5
none
...
|
]
interface gi12
lldp optional-tlv port-desc
30
658
Advertisement
Table of Contents
