Dot1X Traps Authentication Success - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
802. 1 X Commands
OL-32830-01 Command Line Interface Reference Guide
User Guidelines
The traps are sent after the client is set to the quiet state after the maximum
sequential attempts of login.
The command is only applied to the web-based authentication.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a host is set in the quiet state:
switchxxxxxx(config)#
2.28 dot1x traps authentication success
Use the dot1x traps authentication success Global Configuration mode command
to enable sending traps when a host is successfully
authentication method. Use the no form of this command to disable the traps.
Syntax
dot1x traps authentication success {[802.1x] [mac] [web]}
no dot1x traps authentication success
Parameters
•
802.1x—Enables traps for 802.1X-based authentication.
•
mac—Enables traps for MAC-based authentication.
•
web—Enables traps for WEB-based authentication.
Default Configuration
Success traps are disabled.
Command Mode
Global Configuration mode
dot1x traps authentication quiet
by an 802.1X
authorized
2
74
Advertisement
Table of Contents
