Dot1X Unlock Client - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
2
75
User Guidelines
Any combination of the keywords are allowed. At least one keyword must be
configured.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a MAC address is successfully
by the 802.1X MAC-authentication access control.
authorized
switchxxxxxx(config)#
2.29 dot1x unlock client
Use the dot1x unlock client Privileged EXEC mode command to unlock a locked (in
the quiet period) client.
Syntax
dot1x unlock client
interface-id mac-address
Parameters
•
interface-id
—Interface ID where the client is connected to.
•
mac-address
—Client MAC address.
Default Configuration
The client is locked until the silence interval is over.
Command Mode
Privileged EXEC mode
User Guidelines
Use this command to unlock a client that was locked after the maximum allowed
authentication failed attempts and to end the quiet period. If the client is not in the
quiet period, the command has no affect.
dot1x traps authentication success mac
OL-32830-01 Command Line Interface Reference Guide
802. 1 X Commands
Advertisement
Table of Contents
