Spanning-Tree Disable - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
46
Spanning-Tree Commands
no spanning-tree priority
Parameters
priority—Specifies the bridge priority. (Range: 0–61440)
Default Configuration
Default priority = 32768.
Command Mode
Global Configuration mode
User Guidelines
The priority value must be a multiple of 4096.
The switch with the lowest priority is the root of the spanning tree. When more
than one switch has the lowest priority, the switch with the lowest MAC address is
selected as the root.
Example
The following example configures the spanning-tree priority to 12288.
switchxxxxxx(config)#
12288
spanning-tree priority
46.7 spanning-tree disable
Use the spanning-tree disable Interface (Ethernet, Port Channel) Configuration
mode command to disable the spanning tree on a specific port. Use the no form of
this command to enable the spanning tree on a port.
Syntax
spanning-tree disable
no spanning-tree disable
Parameters
N/A
893
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
