Table of Contents
Advertisement
Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller (continued)
PCNTNW-NW-091 The hardware configuration conflicts.
PCNTNW-NW-126 The group bit in the node address override was cleared.
PCNTNW-NW-127 The local bit in the node address override was set.
PCNTNW-NW-164 The device was not found.
PCNTNW-NW-165 The device was not found at IOADDRESS.
PCNTNW-NW-167 PCI scan specified, device not found.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Network driver interface specification 2.01 (OS/2) driver
messages
This section provides explanations of the error messages for the NDIS 2.01 (OS/2)
drivers, and suggested actions to resolve each problem.
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller
PCNTND-1 Unable to open the Protocol Manager.
22
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
Explanation: You tried to load a new frame type for the existing controller. The
hardware assumptions made in doing so are incorrect. This error can also
occur if you try to specify a mode (such as, redundancy) that conflicts with
another specified mode. Action: Make sure that your hardware configuration
matches the software settings.
Explanation: The IEEE address has a group bit that indicates that an address
belongs to a group of stations. This bit is used only as a destination address; it
cannot be used as a source address. You tried to enter a source address with
this bit set. The driver cleared the group bit of the source address. Action:
None necessary, message is for information only.
Explanation: The local bit in the IEEE address format indicates that the
addresses are being managed locally. If you use the node address override
capabilities of this driver to enter a new address, the local bit must be set. You
entered an address without the local bit set. The driver has set the local bit.
Action: None necessary, message is for information only.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller
is enabled, go to "Starting the diagnostic programs" on page 16 to run the
diagnostic programs.
Explanation: The Ethernet controller cannot be found at the I/O address
specified. Action: The Ethernet controller does not require a parameter for the
I/O address. Remove the I/O address parameter.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the problem persists,
go to "Starting the diagnostic programs" on page 16 to run the diagnostic
programs.
Explanation: The Ethernet controller does not require a DMA setting. Action:
None necessary, message is for information only.
Explanation: The NDIS stack is not configured correctly. Action: Check and correct
your configuration.
Advertisement
Table of Contents
Troubleshooting
