Table of Contents
Advertisement
1. Fuel tank breather hose
2. Clamp
3. Diode
4. Hot starter cable
5. Wire harness
6. Hump (frame)
7. Cylinder head breather hose
8. Throttle position sensor lead
9. Neutral switch lead
10. Oil hose
11. Clutch cable
12. Starter motor lead
13. Cable guide
14. Negative battery lead
15. AC magneto lead
16. Brake hose
17. Rectifier/regulator lead
18. Carburetor breather hose
19. Carburetor overflow hose
20. Catch tank breather hose
21. Hot starter cable protector
22. Rubber cap
A. Insert the end of the fuel tank breather
hose into the hole in the steering stem.
B. Fasten the throttle cable, hot starter cable
and rectifier/regulator lead onto the frame.
Locate the clamp under the throttle cable
on the right side of the frame, and face its
ends, as well as the tie ends, downward.
C. Fasten the diode (at the marking), throttle
cable and hot starter cable onto the frame.
Locate the clamp end facing toward the
lower right of the frame and with the tie end
facing downward.
D. Fasten the wire harness, throttle position
sensor lead, starter motor lead and nega-
tive battery lead onto the frame. Pass the
clamp through the hole in the stay (air cut-
off valve). Locate the clamp end facing to-
ward the lower side of the frame and cut off
the tie end.
E. Pass the carburetor breather hoses, carbu-
retor overflow hose and catch tank breath-
er hose between the connecting rod and
cross tube (frame).
F. Fasten the neutral switch lead and oil hose
together with the plastic locking ties and cut
off the tie ends.
G. Fasten the neutral switch lead and AC
magneto lead onto the frame. Locate the
clamp end facing toward the outside of the
frame and tie end facing toward the rear of
the frame.
CABLE ROUTING DIAGRAM
H. Pass the clutch cable through the cable
guide.
I.
Fasten the starter motor lead, AC magneto
lead and neutral switch lead onto the
frame. Locate the clamp end facing toward
the rear of the frame and cut off the tie end.
J. Fasten the clutch cable, starter motor lead,
negative battery lead, AC magneto lead
and neutral switch lead onto the frame. Lo-
cate the clamp end facing toward the rear
of the frame and cut off the tie end.
K. Pass the neutral switch lead and AC mag-
neto lead on the inside of the wire harness.
L. Fasten the clutch cable, AC magneto lead
and neutral switch lead onto the frame. Lo-
cate the clamp end near the clutch cable
and cut off the tie end.
M. Pass the clutch cable and wire harness
through the cable guide.
N. Locate the couplers in the frame recess.
O. Pass the carburetor breather hoses, carbu-
retor overflow hose and catch tank breath-
er hose so that the hoses do not contact the
rear shock absorber.
P. Secure the coupler by pushing it into the
hole in the headlight unit.
Q. Fasten the throttle position sensor lead and
the hot starter cable.
R. Locate the clamp between the hot starter
cable protector and rubber cap.
2-27
Hide quick links:
Advertisement
Table of Contents
