Sntp Anycast Client Enable - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Clock Commands
78-21075-01 Command Line Interface Reference Guide
User Guidelines
Use the sntp broadcast client enable Interface Configuration mode command to
enable the SNTP Broadcast client on a specific interface.
After entering this command, you must enter
to be run. If this command is not run, the switch will not synchronize with Broadcast
servers.
Example
The following example enables SNTP Broadcast clients.
s
switchxxxxxx(config)#
7.10
sntp anycast client enable
The sntp anycast client enable Global Configuration mode command enables the
SNTP Anycast client. Use the no form of this command to disable the SNTP
Anycast client.
Syntax
sntp anycast client enable
no sntp anycast client enable
Parameters
N/A
Default Configuration
The SNTP anycast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use this command to enable the SNTP Anycast client.
sntp broadcast client enable
clock source snmp
for the command
7
143
Advertisement
Table of Contents
