Sntp Server - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Clock Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
Example
The following example enables polling for SNTP predefined unicast clients.
switchxxxxxx(config)#
7.15
sntp server
The sntp server Global Configuration mode command configures the device to
use the SNTP to request and accept Network Time Protocol (NTP) traffic from a
specified server (meaning to accept system time from an SNTP server). Use the
no form of this command to remove a server from the list of SNTP servers.
Syntax
sntp server {
ip-address
ip-address
no sntp server {
Parameters
•
ip-address—Specifies the server IP address. This can be an IPv4, IPv6 or
IPv6z address. See
•
hostname—Specifies the server hostname. Only translation to IPv4
addresses is supported. (Length: 1–158 characters. Maximum label length
for each part of the hostname: 63 characters)
•
poll—Enables polling.
•
keyid
key
—Specifies the Authentication key to use when sending packets
to this peer. (Range:1–4294967295)
Default Configuration
No servers are defined.
sntp unicast client poll
|
hostname
} [
poll
] [
key keyid
hostname
|
}
IPv6z Address
Conventions:
]
7
147
Advertisement
Table of Contents
