Cisco 300 Series Cli Manual page 198

Small business 300 series managed switches command line interface guide release 1.3

Table of Contents

snmp-server community

prefix-length] [

no snmp-server community

community-string—Define the password that permits access to the SNMP

protocol. (Range: 1–20 characters). This string is used as an input parameter

snmp-server user

ro—Specifies read-only access (default)

rw—Specifies read-write access

su—Specifies SNMP administrator access

snmp-server view

configurations is imposed on the user). The view defines the objects

available to the community. It is not relevant for su, which has access to the

whole MIB. If unspecified, all the objects, except the community-table and

SNMPv3 user and access tables, are available. (Range: 1–30 characters)

ip-address—Management station IP address. The default is all IP

addresses. This can be an IPv4 address, IPv6 or IPv6z address. See

Conventions.

mask—Specifies the mask of the IPv4 address. This is not a network mask,

but rather a mask that defines which bits of the packet's source address are

compared to the configured IP address. If unspecified, it defaults to

255.255.255.255. The command returns an error if the mask is specified

without an IPv4 address.

prefix-length—Specifies the number of bits that comprise the IPv4 address

prefix. If unspecified, it defaults to 32. The command returns an error if the

prefix-length is specified without an IPv4 address.

Default Configuration

No community is defined

Command Mode

Global Configuration mode

Network Management Protocol (SNMP) Commands

string [ro | rw | su]

community-string [ip-address]

for SNMP v3.

—Specifies the name of a view configured using the

(no specific order of the command

78-21075-01 Command Line Interface Reference Guide

ip-address | ipv6-address