Show Interfaces Status - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
23
358
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display all interfaces. If detailed is not used, only present ports are displayed.
Command Mode
EXEC mode
Example
The following example displays the configuration of all configured interfaces:
switchxxxxxx# show interfaces configuration
Port
Type
Duplex
------ --------- ------
gi1
1G-Copper Full
gi2
1G-Copper Full
PO
Type
Speed
------
------ -----
Po1
23.16 show interfaces status
Use the show interfaces status EXEC mode command to display the status of all
interfaces or of a specific interface.
Syntax
show interfaces status
Parameters
•
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Flow
Speed
Neg
control
-----
-------- -------
10000
Disabled Off
1000
Disabled Off
Flow
Neg
Control
--------
-------
Disabled
Off
[interface-id | detailed
78-21075-01 Command Line Interface Reference Guide
Ethernet Configuration Commands
Admin
Back
State
Pressure
-----
--------
Up
Disabled
Up
Disabled
Admin
State
-----
Up
]
Mdix
Mode
----
Off
Off
Advertisement
Table of Contents
