Bridge Multicast Forbidden Address - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Address Table Commands
78-21075-01 Command Line Interface Reference Guide
You can execute the command before the VLAN is created.
Examples
Example 1 - The following example registers the MAC address to the bridge table:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
Example 2 - The following example registers the MAC address and adds ports
statically.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
29.4
bridge multicast forbidden address
Use the bridge multicast forbidden address Interface Configuration (VLAN) mode
command to forbid adding or removing a specific Multicast address to or from
specific ports. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forbidden address {
ipv4-multicast-address
port-channel-list
}
no bridge multicast forbidden address {
Parameters
•
mac-multicast-address | ipv4-multicast-address—Specifies the group
Multicast address.
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
interface vlan
8
bridge multicast address
interface vlan
8
bridge multicast address
mac-multicast-address |
{add | remove} {ethernet interface-list | port-channel
}
mac-multicast-address
—Specifies a list of Ethernet ports. Separate
29
01:00:5e:02:02:03
01:00:5e:02:02:03
add
}
gi1-2
407
Advertisement
Table of Contents
