Ipv6 Mld Snooping Vlan Static - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
IPv6 MLD Snooping Commands
78-21075-01 Command Line Interface Reference Guide
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 forbidden mrouter interface
39.7
ipv6 mld snooping vlan static
Use the ipv6 mld snooping vlan static Global Configuration mode command to
register a IPv6-layer Multicast address to the bridge table, and to add statically
ports to the group. Use the no form of this command to remove ports specified as
members of a static Multicast group.
Syntax
vlan vlan-id
ipv6 mld snooping
no ipv6 mld snooping
Parameters
•
vlan-id—Specifies the VLAN.
•
ipv6-address—Specifies the IP multicast address
•
interface-list—Specifies list of interfaces. The interfaces can be from one of
the following types: Ethernet port or Port-channel.
Default Configuration
No Multicast addresses are defined.
Command Mode
Global configuration mode
User Guidelines
Static multicast addresses can only be defined on static VLANs.
You can execute the command before the VLAN is created.
You can register an entry without specifying an interface.
Using the no command without a port-list removes the entry.
ipv6-address interface [interface-list]
static
vlan vlan-id
ipv6-address interface [interface-list]
static
39
gi1
659
Advertisement
Table of Contents
