Ipv6 Mld Last-Member-Query-Interval - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
39
IPv6 MLD Snooping Commands
Address and Source Specific Queries sent before the router assumes there are no
listeners for a particular source.
Use the no format of the command to return to default.
Syntax
count
ipv6 mld last-member-query-count
no ipv6 mld last-member-query-count
Parameters
count—The number of times that group- or group-source-specific queries are sent
upon receipt of a Leave message. (Range: 1–7)
Default Configuration
The value of the Robustness variable.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command provides the maximum response time value if this value is not
received in MLD general query messages. A field for this value is present in
MLDv2 general query messages, but this field may be blank. There is no field for
this value in MLDv1 general query messages.
Example
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ipv6 mld last-member-query-count 3
39.11 ipv6 mld last-member-query-interval
Use the ipv6 mld last-member-query-interval interface configuration command to
configure the Last Member Query Interval. Use the no format of the command to
return to default.
Syntax
milliseconds
ipv6 mld last-member-query-interval
662
78-21075-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
