Ip Arp Inspection Logging Interval - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
42
704
Example
The following example assigns the static ARP binding list Servers to VLAN 37.
switchxxxxxx(config)#
42.27 ip arp inspection logging interval
Use the ip arp inspection logging interval Global Configuration mode command to
set the minimum time interval between successive ARP SYSLOG messages. Use
the no form of this command to restore the default configuration.
Syntax
ip arp inspection logging interval {
no ip arp inspection logging interval
Parameters
•
seconds—Specifies the minimum time interval between successive ARP
SYSLOG messages. A 0 value means that a system message is
immediately generated. (Range: 0–86400)
•
infinite—Specifies that SYSLOG messages are not generated.
Default Configuration
The default minimum ARP SYSLOG message logging time interval is 5 seconds.
Command Mode
Global Configuration mode
Example
The following example sets the minimum ARP SYSLOG message logging time
interval to 60 seconds.
switchxxxxxx(config)#
DHCP Snooping and ARP Inspection Commands
ip arp inspection list assign
seconds | infinite}
ip arp inspection logging interval
78-21075-01 Command Line Interface Reference Guide
37 servers
60
Advertisement
Table of Contents
