Ipv6 Address Link-Local - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
44
728
44.4
ipv6 address link-local
Use the ipv6 address link-local command in Interface Configuration mode to
configure an IPv6 link local address for an interface and enable IPv6 processing on
the interface.
Use the no form of this command to remove the manually configured link local
address from the interface.
Syntax
ipv6 address
ipv6-prefix
no ipv6 address [link-local]
Parameters
•
ipv6-address—Specifies the IPv6 address assigned to the interface. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
Default Configuration
The default Link-local address is defined.
Command Mode
Interface Configuration
User Guidelines
The switch automatically generates a link local address for an interface when IPv6
processing is enabled on the interface, typically when an IPv6 address is
configured on the interface. To manually specify a link local address to be used by
an interface, use the ipv6 address link-local command.
The ipv6 address link-local command cannot be applied to define an IPv6 address
on an ISATAP interface.
Using the no IPv6 address command without arguments removes all
manually-configured IPv6 addresses from an interface, including link local
manually configured addresses.
link-local
78-21075-01 Command Line Interface Reference Guide
IPv6 Router Commands
Advertisement
Table of Contents
