Cisco 300 Series Cli Manual page 741

Small business 300 series managed switches command line interface guide release 1.3

Table of Contents

IPv6 Router Commands

78-21075-01 Command Line Interface Reference Guide

interface as being a duplicate address, the processing of IPv6 packets is

disabled on the interface and the interface is marked "stalled." If IPv6 is not

enabled, the interface is marked "disabled."

link-local address—Displays the link-local address assigned to the

Global Unicast address(es):—Displays the global Unicast addresses

assigned to the interface. The type is manual or autoconfig.

Joined group address(es):—Indicates the Multicast groups to which this

interface belongs.

—Maximum transmission unit of the interface.

ICMP error messages—Specifies the minimum interval (in milliseconds)

between error messages sent on this interface.

ND DAD—The state of duplicate address detection on the interface

(enabled or disabled).

number of DAD attempts—Number of consecutive neighbor solicitation

messages that are sent on the interface while duplicate address detection

is performed.

ND reachable time—Displays the neighbor discovery reachable time (in

milliseconds) assigned to this interface.

MLD Version—The version of MLD

Tunnel mode—Specifies the tunnel mode: manual, 6to4, auto-tunnel or

Tunnel Local IPv4 address—Specifies the tunnel local IPv4 address and

have one of the following formats:

ipv4-address

Tunnel Remote Ipv4 address—Specifies the tunnel remote IPv4 address

Example 3. The show ipv6 interface command displays information about the

specified ISATAP tunnel:

interface-id