Cisco 300 Series Cli Manual page 780
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
48
780
Parameters
•
protocol—The name or the number of an IP protocol. Available protocol
names are: icmp (58), tcp (6) and udp (17). To match any protocol, use the
ipv6 keyword. (Range: 0–255)
•
source-prefix/length—The source IPv6 network or class of networks about
which to set permit conditions. This argument must be in the format
documented in RFC 3513 where the address is specified in hexadecimal
using 16-bit values between colons.
•
destination-prefix/length—The destination IPv6 network or class of
networks about which to set permit conditions. This argument must be in
the format documented in RFC 3513 where the address is specified in
hexadecimal using 16-bit values between colons.
•
number
dscp
—Specifies the DSCP value. (Range: 0–63)
•
number
precedence
•
icmp-type—Specifies an ICMP message type for filtering ICMP packets.
Enter a number or one of the following values: destination-unreachable (1),
packet-too-big (2), time-exceeded (3), parameter-problem (4), echo-request
(128), echo-reply (129), mld-query (130), mld-report (131), mldv2-report
(143), mld-done (132), router-solicitation (133), router-advertisement (134),
nd-ns (135), nd-na (136). (Range: 0–255)
•
icmp-code—Specifies an ICMP message code for filtering ICMP packets.
(Range: 0–255)
•
destination-port—Specifies the UDP/TCP destination port. You can enter a
range of ports by using a hyphen. E.g. 20 - 21. For TCP enter a number or
one of the following values: bgp (179), chargen (19), daytime (13), discard (9),
domain (53), drip (3949), echo (7), finger (79), ftp (21), ftp-data 20), gopher
(70), hostname (42), irc (194), klogin (543), kshell (544), lpd (515), nntp (119),
pop2 (109), pop3 (110), smtp (25), sunrpc (1110, syslog (514), tacacs-ds
(49), talk (517), telnet (23), time (37), uucp (117), whois (43), www (80). For
UDP enter a number or one of the following values: biff (512), bootpc (68),
bootps (67), discard (9), dnsix (90), domain (53), echo (7), mobile-ip (434),
nameserver (42), netbios-dgm (138), netbios-ns (137), non500-isakmp
(4500), ntp (123), rip (520), snmp (161), snmptrap (162), sunrpc (111), syslog
(514), tacacs (49), talk (517), tftp (69), time (37), who (513), xdmcp (177).
(Range: 0–65535)
•
source-port—Specifies the UDP/TCP source port. Predefined port names
are defined in the destination-port parameter. (Range: 0–65535)
—Specifies the IP precedence value.
78-21075-01 Command Line Interface Reference Guide
ACL Commands
Advertisement
Table of Contents
