TABLE OF CONTENTS
1.
GENERAL
Location of Controls ........................................................ 3
Installation (US Model) ................................................... 4
Installation (E, Australian Model) ................................... 5
Connection ....................................................................... 6
2.
.......................................................... 8
3.
4.
5.
Tuner Section ................................................................... 16
6.
6-2. Printed Wiring Boards -MAIN Section- ........................ 20
6-3. Schematic Diagram -MAIN Section- ............................ 23
6-4. Printed Wiring Board -CONTROL Section- ................. 27
6-5. Schematic Diagram -CONTROL Section- .................... 29
7.
8.
........... 10
....................... 16
................................................ 33
................................ 37
SERVICING NOTES
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚ C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
- 2 -