Table of Contents
Advertisement
QUICK START GUIDE
9. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over
tighten screws.
10.Ensure the screws sit flush against the bottom of the
channel.
Integrated Panel
11.Remove clamps from door.
NOTICE
If panel requires additional adjustment after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
12.Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated.
Integrated Panel
10
u-line.com
Advertisement
Table of Contents
